Share
Pin
Tweet
Send
Share
Send
Work sequence.
In order to fold such a fish, prepare a sheet of yellow paper. The back of the paper should be white.
Fold the upper right corner of the sheet diagonally in half with the wrong side inward. Cut off the part of the sheet that remains on the left.
Expand the sheet. You have a square with one diagonal fold.
Fold the square along the other diagonal. The fold should be on top.
Bend the sides of the triangle downward, aligning the side corners with the bottom. The result is two movable triangles.
Fold these triangles in half horizontally.
Above again, two triangles turned out. Bend them in half and straighten them again. The folds defined their middle.
Fold the upper parts of the triangles in half again, aligning their sides with the midline.
At the bottom of the craft, two sheets appeared in the form of triangles. Bend one of the triangles up to 3/4 of its height. Iron the bend.
Grasp this fold and bend up again, making a fold exactly in the center of the craft.
You got a square on which all the work you did was in the upper part. And below was a single triangular leaflet. In the middle of the workpiece on this triangle, make marks on both sides at a distance of 1 cm from the center. Make cuts on both sides of the marks.
Bend the bottom triangle for the craft. You will get such a cap.
Expand it wider.
Grasp the side corners from the bottom and connect the right side of the cap with its left side, while bending the cut part of the craft to the right.
Holding the craft in a half-open state, fold its tail part along the fold with the white side inward. Turn the right triangle (tail) 90 degrees up so that its base takes a vertical position. The top in the area of the cut, slightly push into the crafts.
And just now iron all the folds. Since the tail of the fish is movable, give it the correct position.
Cut out two small circles from black paper and glue. Now the fish has eyes.
The fish is ready.
Share
Pin
Tweet
Send
Share
Send