Clamps are present in almost every workshop or garage. That's just often they are lying in a heap on a table or in a drawer. And getting them is not always convenient.
In this review, the author shows how you can make your own simple organizer for clamps, which is attached to the wall.
The main material for the manufacture of the organizer is a plastic pipe with a diameter of 32 mm. It will be necessary to cut this pipe into separate pieces 9 cm long.
Then, in each piece of plastic pipe, it is still necessary to make cuts with a width of about 5-7 mm. Edges will need to be processed with sandpaper if necessary.
The main stages of work
At the next stage, the author cuts two pieces of plywood: one - 80 mm wide, the second - 40 mm. Of these, you will need to assemble a small shelf (just glue the blanks with each other at an angle of 90 degrees).
Next, you need to screw the cut pieces of the tube to the shelf from plywood for self-tapping screws. Two screws are quite enough for each segment.
After that, it remains only to saw two planks with a beveled edge at 45 degrees from plywood (it is also called the "French plank").
We fix one bar to the wall, the second - if necessary, cut to the desired width and fasten to a shelf of plywood.
For details on how to make a do-it-yourself organizer for clamps, see the video on our website.
